Filter results
Validate filters
11,95 €
ATIThis rear arm brake hose for 2cv Van (03/1963-01/1972) - 4. 5mm is a higher quality than the original.
This rear brake hose on arm for 2CV in 4. 5mm is compatible with mounts requiring a 9 wrench and mounts at the end of the rear hose. It...
Only 3 in stock
Only 3 in stock
Delivery mode
Collect at store Wambrechies (France) : Free.
Home delivery : on estimate.
Sent by MECATECHNIC on: Friday, May 24, 2024
Description Product
This rear arm brake hose for 2cv Van (03/1963-01/1972) - 4.5mm is a higher quality than the original.
This rear brake hose on arm for 2CV in 4.5mm is compatible with mounts requiring a 9 wrench and mounts at the end of the rear hose. It was only used on the 2CV sedan on the Hybrid front banjo mounting and a few months at the launch of the 2CV4 and 2CV6. It was replaced in June 1970 by a complete system in 3.5mm and key of 8.
Caution!!! your vehicle may have been modified, check the diameter of the wheel cylinder and the key needed to tighten the brake hose ends.
Use only a DOT4 or DOT5 brake fluid.
The LHM fluid is very corrosive to parts that are not intended for its use, a bad brake fluid could severely damage your braking system.
Length (mm)
400
Diameter (mm)
4.5
Materials
Cuivre
Thread
M9 x1.25
Brake fluid
DOT 4, DOT 5
Customer review
No commentary about the product
With Trusted Shops, we can improve directly thanks to your comments posted on the MECATECHNIC website
Your questions
Vehicle compatibility