
Read more
1 Results
sort by
In stock
A roof panel is not stamped as a single piece with the body sides: it is welded to them, and this joint forms a groove or channel running the full length of the roof. The moulding covers this, for aesthetic reasons but above all to protect it.
This groove effectively acts as a trap for water and debris. Without the moulding, or if the moulding no longer fits snugly, water pools directly on the weld and the original sealant. Corrosion sets in there, unseen, and becomes apparent years later as blisters along the roof, in an area where repairs are costly. Driving without a roof moulding, or with one that is gaping, is therefore tantamount to leaving an open wound on the bodywork.
All these parts are asymmetrical and must be ordered per side – left or right – as viewed from the driver’s seat.
The moulding is clipped into place, sometimes with a seal that has become stuck over time. Use a flat plastic tool, never a screwdriver: the gutter panel is thin and visible, and any mark will not disappear without repainting.
Above all, make the most of the removal process to address whatever you find underneath. Clean the groove down to sound metal, treat any corrosion if present, and reapply the sealant to the weld before refitting. Fitting a new moulding onto a corroded groove is simply closing the lid on the problem. Make sure you have new clips to hand: almost all of them break during removal, and a poorly secured trim panel will vibrate, whistle and eventually come away.
The finish of the roof moulding must match the rest of the vehicle’s trim, as it is the most visible line on the car and any difference in shade is immediately noticeable.
Chrome is shiny and cold, whilstpolished or anodised aluminium is more matt and slightly softer in appearance; black is typical of later finishes and understated versions. If you’re only replacing one side, compare it in daylight with the original side: a new anodised trim next to a forty-year-old anodised one won’t have the same shade, and it’s sometimes better to replace both sides than just one.

Consult the details of the engine variants, chassis and versions offered for this model