Suspension plates for Volkswagen Beetle

Original-type suspension blade (non-adjustable), right- or left-hand mounting,
sold individually.

For VW Cox (09/1952-07/1959)
with trumpet rear axle
torsion bars length 627mm.

These adjustable suspension blades replace the original ones and allow for height adjustment of the rear suspension, without decranking the torsion bars. Installation with 2 silent blocks 2" (51 mm) for the outside (ref. VJ511024 not supplied) and 48 mm for the inside (VJ511025)

These adjustable suspension blades replace the original ones and allow height adjustment of the rear suspension, without removing the torsion bars. Sold in pairs.

For VW Beetle since 09/1967->
Chassis: since N° 118 071 440->
Models: 1500 (automatic), 1302, 1303, with original cardanic rear axle, equipped with 675 mm long torsion bars and double suspension leafs (arm plates sandwiched).
These adjustable blades can be mounted on a single-blade system by re-drilling the oblong mounting holes.)

On some models, silentblocs covers with shims are required for 1302 / 1303 (VS03100).

Assembly with 2 silentblocs 2" (51 mm) for outside (ref.VJ511024 not supplied) and 48 mm for inside.

These adjustable suspension blades replace the original ones and allow height adjustment of the rear suspension, without removing the torsion bars.
For VW Cox (09/1952-07/1959) with trumpet rear axle fitted with original torsion bars, length 627 mm.
Chassis no. 397 023 ->2 528 667.

Mounting with 2 silentblocs 2" (51 mm) for outside (ref.VJ511024 not supplied) and 2 silentblocs 1 7/8" (48 mm) for inside (ref. VJ511023 not supplied).

These adjustable suspension blades replace the original ones and allow height adjustment of the rear suspension, without removing the torsion bars. Sold in pairs.
Silentblock covers with shims for 1302 / 1303 (VS03100) are required on some models.

For VW Beetle from 09/1967->
Chassis: since N° 118 071 440->
Equipped with torsion bars, length 552 mm

Original type suspension blade (non-adjustable), Fitted on left or right-hand side, sold per unit.

For Beetle from 08/1959->
with rear axle with flared tubes
553 mm long torsion bars.
From chassis no. 2 528 668->

These adjustable suspension blades replace the original ones and allow height adjustment of the rear suspension, without removing the torsion bars.
For VW Cox (09/1952 -07/1959) with cardanic rear axle , but fitted with original torsion bars, length 627 mm.
Chassis no. 397 023 ->2 528 667.
On some models, you'll need silentblock covers with shims for 1302 / 1303 (VS03100).

Please measure the length of your torsion bars before ordering. Assembly with 2 silentblocs 2" (51 mm) for outside (ref.VJ511024 not supplied) and 48 mm for inside.