New turbo without exchange for Audi TT 8J Coupé and Roadster 2.0L TFSI (04/2006-04/2010)

New turbo without exchange for Audi TT 8J Coupe and Roadster:

Coupé :
- 2.0L TFSI 200hp phase 1 from 04/2006 to 04/2010 (BWA engine code)
- 2.0L TFSI Quattro 200hp phase 1 from 04/2006 to 04/2010 (BWA engine code)
- 2.0L TFSI 200hp phase 1 from 04/2006 to 04/2010 (BPY engine code)
- 2.0L TFSI Quattro 200hp phase 1 from 04/2006 to 04/2010 (BPY engine code)
- 2.0L TFSI 200hp phase 1 from 04/2006 to 04/2010 (engine code CCZA)
- 2.0L TFSI Quattro 200hp phase 1 from 04/2006 to 04/2010 (engine code CCZA)

Roadster :
- 2.0L TFSI 200hp phase 1 from 03/2007 to 04/2010 (engine code BWA)
- 2.0L TFSI Quattro 200hp phase 1 from 03/2007 to 04/2010 (BWA engine code)
- 2.0L TFSI 200hp phase 1 from 03/2007 to 04/2010 (BPY engine code)
- 2.0L TFSI Quattro 200hp phase 1 from 03/2007 to 04/2010 (BPY engine code)
- 2.0L TFSI 200hp phase 1 from 03/2007 to 04/2010 (engine code CCZA)
- 2.0L TFSI Quattro 200hp phase 1 from 03/2007 to 04/2010 (engine code CCZA)

The turbocharger is sold complete with seals. No instructions are necessary.

Precautions must be taken when replacing a turbocharger:
- The oil circuit must be cleaned to remove any residue that may obstruct the circuit.
- replace the oil and oil filter
- Check and clean oil intake and return ducts
- Check air and breather hoses too
- Using a syringe, fill the turbo with oil through the turbo oil inlet, then prime the turbine by hand.
- Once the new turbo has been fitted, start the engine and let it idle for 10 minutes. Before stopping the engine, let it idle for a few seconds (do not accelerate suddenly before stopping).