Drive shaft support for BMW E32

FEBIdriveshaft centering bush for BMW 7 Series E32 :

Bmw 7 Series E32 :

- 730i 6cyl 197hp from 07/1986 to 04/1994 (engine code m30b30)
- 730iL 6cyl 197hp from 12/1987 to 03/1994 (engine code m30b30)
- 730i 8cyl 218hp from 05/1991 to 04/1994 (engine code m60b30)
- 730iL 8cyl 218hp from 06/1992 to 03/1994 (engine code m60b30)
- 735i 6cyl 220hp from 10/1985 to 07/1992 (engine code m30b35)
- 735iL 6cyl 220hp from 06/1987 to 07/1992 (engine code m30b35)
- 740i 8cyl 286hp from 09/1991 to 03/1994 (engine code m60b40)
- 740iL 8cyl 286hp from 10/1991 to 03/1994 (engine code m60b40)

This bushing is pressed into the rear part of the gearbox output flange at flector level and allows correct alignment of thelongitudinal shaft (the rod at the end of the transmission shaft is inserted into this centering bushing).

Without it, the shaft will not be correctly aligned and will cause strong vibrations in the chassis.

WARNING: Not suitable for Bmw 7 Series E32 750i v12 engine code m70.

MEYLE OE driveshaft bearings and brackets for BMW 7 Series E32 :

Bmw 7 Series E32 :

- 740i 8cyl 286hp from 09/1991 to 03/1994 automatic gearbox (engine code m60b40)
- 740iL 8cyl 286hp from 10/1991 to 03/1994 automatic gearbox (engine code m60b40)
- 750i 12cyl 300hp from 07/1987 to 03/1994 automatic gearbox (engine code m70)
- 750iL 12cyl 300hp 11/1986 to 03/1994 automatic transmission (engine code m70)
- 750iLS 12cyl 300hp from 09/1988 to 03/1994 automatic gearbox (engine code m70)

WARNING: Not suitable for 6-cylinder versions and 730i v8 engine code m60b30.