49,90 €
ATIwhose 0,15€ of eco-participation
This adapter will enable you to use a ratchet wrench as a torque wrench, with a torque measurement range from 40 to 200Nm and an accuracy of /- 2%.
It can also be used for tightening or loosening.
Digital dial with 1/2" square...
In stock
In stock
9h 02 mins left, for a shipment today
Delivery mode
Home delivery : 39.00€
Collect at store Wambrechies (France) : Free
Description Product
This adapter will enable you to use a ratchet wrench as a torque wrench, with a torque measurement range from 40 to 200Nm and an accuracy of /- 2%.
It can also be used for tightening or loosening.
Digital dial with 1/2" square
Supplied without type 2032 battery
Replacing the battery :
When changing the battery, the adapter must be reset to its initial state.
- Before inserting the new battery, press the ( ) button.
- Insert the battery (while holding down the ) button).
- Once the battery is in place, keep pressing for at least 6 seconds.
Brand
ToolAtelier
4.7
19 Feedback
5
13 Feedback
4
6 Feedback
3
0 Feedback
2
0 Feedback
1
0 Feedback
With Trusted Shops, we can improve directly thanks to your comments posted on the MECATECHNIC website
Sort by
Best reviews
Very precise tightening, it triggers at the same time as my Facom dynamo wrench. The only problem was that the battery supplied was a dead CR2032...
Product corresponds to my expectations
Very good product to be seen in use
Very practical for screwing to the required torque in metric and inch sizes
Very good product, to be seen over time.